Connectivity will still be achieved through the remaining active interface on the host via the other N5K. So it is possible to isolate the N2K but not advisable, and since vPC became available in 4. Register now to get updates on promotions and coupons. If you lost all uplink then the N2K would go down and standby NIC should then forward upon link-failure of the active. There are essentially two deployment scenarios one for each end-host mode basically The important note here is that active-active is not supported where each N2K would be connected to the other N5K Peer-Switch as depicted below
© 2020 westphillystamper.com - All rights reserved. All Models are over 21 y.o.